9 Alarms
28
On displaying the detailed information, the alarm
message/system warning is marked as "read" and the alarm
counter is marked down.
Click on the Mark all as read button to mark all alerts as "read".
9.2 Alarm settings
Creating and displaying alarm settings
• Click on the + New alarm setting button to create a new
alarm setting.
Existing alarm settings are displayed below the button.
• Click on the title of an alarm setting to display it.
Configuring and editing a displayed alarm setting
The following settings can be defined and edited:
• Title: designation of the alarm setting (required field).
• Measuring points: Measuring point group/measuring point
which is to be monitored. Click on the checkbox in front of
the measuring point group/measuring point.
• Alarm limit value 1 and 2: Different limit value ranges
which can be defined for different periods.
• Upper limit, lower limit: Are values which are to be
monitored.
• Alarm delay: Minimum duration of a limit value violation
before an alarm is triggered.
The time intervals between measurements (measurement rate
should be smaller than the alarm delay (e.g. measurement rat
5 minutes, alarm delay = 15 minutes).
• Timed control: Define individual alarm periods for which
the alarm limit values 1 and 2, or no alarm at all, apply. To
define the alarm value 1 and 2, double-click on a time point
in the table or pull open the desired time period with the
mouse. In periods in which the the table is left empty, you
receive no alarm.
If you have not defined alarm periods, the alarm limits will be
active 24 hours a day.
If alarm periods have been defined, the limit value alarms are
active only in the marked period.
• Channel alarms: alarms in the event of a defective sensor.
To Next Page
Loading...
