10 Configuration
34
10.6 WiFi data loggers
A summary of all WiFi data loggers logged on is displayed.
• Click on the Details button to display more information.
• Click on the Deactivate or Activate button to deactivate or
activate WiFi data loggers.
Configuring a WiFi data logger
• Click on the Configure button to change the configuration.
The following settings can be defined and edited:
• Name of the WiFi data logger: designation of the WiFi
data logger (required field). Condition at delivery:
Model_Serial number
• Description: description of the WiFi data logger.
• Select battery type: set the battery type used. For the
battery capacity to be displayed correctly, the correct
battery type must be selected.
• Display: switch the display of the WiFi data logger on or
off.
• Name of the measuring point: designation of the
measuring point (required field).
• Measuring cycle: interval at which readings are obtained.
Set the measuring cycle using the slide control.
• Day communication cycle and Night communication
cycle: interval at which readings are transmitted to the
Testo Cloud. Select the start time for the day
communication cycle and the night communication cycle.
Set the communication cycle using the slide control.
• Channel name: designation of the measurement channel
(required field). Condition at delivery: Model_Serial
number_Channel number
• Select unit: unit in which the readings are displayed.
• Select sensor type (only for model T2, T3): sensor type
used by the measurement channel.
• Save
: click on the button to save the settings.
• Deactivate or Activate
: click on the button in order to
deactivate or activate measurement channels or WiFi data
loggers.
To Next Page
