6 Using the product
103
Designation Description
Group alarm
settings
Enter the group name.
System settings
Alarm conditions: settings for lower limit
delay [Measurements], upper limit delay
[Measurements] and trigger
acknowledged alarms after [min]
Alarm output Saveris Base: settings for
relays, audible signal and light signal.
[Apply entries] Saves the alarm settings of an alarm
group.
[Print] Creates a file containing a summary of
the alarm settings for probes and the
base.
Activate/deactivate
all
Activates all available alarm settings.
Creating a new group
1. Right-click on component, then click on [Insert into new
group].
- A new alarm group is created.
2. Overwrite the default names in Group alarm settings Group
selection list.
Move to…
1. Right-click on component, then click on [Move to …].
- A selection of available alarm groups is displayed.
2. Click on required alarm group.
- The component is assigned to the selected alarm group.
Remove from group
1. Right-click on component, then click on [Remove from group].
- The component is removed from the assigned alarm group.
Delete group
1. Right-click on component, then click on [Delete this group].
- The assigned alarm group is deleted, all components that were
assigned to this group are now without an alarm group.
To Next Page
Loading...
Need help?
General
