Inserting the Battery
Your miniPAT comes complete with a PP3 battery in the
carry case.
Before use for the first time you need to insert the battery
into the tester. To do this:
1)
Remove the tester from the green silicone protective boot
and unscrew the two screws in the side of the tester.
2)
Lift off the lid and connect the battery to the connector.
3)
Refit the lid in the reverse of the manner above, taking
care not to damage any cable within.
Your miniPAT is now ready to use.
Low Battery Warning
The miniPAT is tted with a low battery warning light which
will light up when the battery voltage is below 7V (volts).
If this happens, replace the battery.
Calibration
It is recommended that the unit should be calibrated every
12 months to ensure reading accuracy.
6
To Next Page
Loading...