Visual Checking
Before carrying out any type of test on an appliance you
must check the following:
1)
Plug
- For signs of cracks, damage and/or overheating.
- Ensure the cable is tightly in the plug and not loose.
2)
Cable
- For splits in the cable and/or areas that have been
covered with insulating tape.
3)
Appliance
- That the switch functions correctly and that it's not
cracked or damaged.
- There are no signs of overheating.
- All covers are in place.
If you nd any of the above faults the appliance should
be withdrawn from service and not used.
Do not carry out any testing if you nd an appliance that
is damaged in any way.
Before testing any appliance try and make sure any
switches are in the ON position.
7
To Next Page
Loading...