Tetra APS 50 - PRODUCT BASICS

5
UK
Note the symbols on the device
The device is protected against water splashes.
Intended for indoor use only.
Protection class II: Metal parts that could
potentially conduct electricity in the event of a fault
are insulated.
Do not dispose of the device with household waste;
send for recycling.
PRODUCT BASICS
The Tetra APS aquarium air pump supplies the aquarium water
with air and therefore with vital oxygen.
Fig. A Description
1
Connection cable with plug
2
Air inlet with air filter
3
Air outlet
• E.g. to connect an air stone
4
Air pump hose with 4 mm internal diameter (not
included in the set).
• E.g. Tetra AH 50-400 air pump hose.
5
Flow control valve
• To regulate the quantity of air.
6
Tetra CV check valve (not included in the set)
• If the pump is positioned below the water level, the
check valve prevents water from getting into the
pump.
7
T-piece (APS 300 and 400 only)
• To join both air outlets.
Intended use
The Tetra APS aquarium air pump should only be used:
• to supply air to an indoor aquarium,
• in indoor areas, for private use,
• in line with the technical data.