EN
9
How to proceed:
1. Completely open the stop valves at the inlet IN and
outlet OUT.
2. Press the start button several times in quick succes-
sion until the filter starts filling with water.
3. Wait until water is visible in the hose to the outlet
pipe.
4. Connect the plug of the filter to the power socket.
– The pump in the motor head will switch on auto-
matically.
5. Set the flow rate.
– Set the desired flow rate with the stop valve at the
inlet IN.
– The stop valve at the outlet OUT remains com-
pletely open.
CLEANING AND MAINTENANCE
WARNING
Dangerous electrical voltage!
Death or severe injury from electrocution.
Switch off the appliance, disconnect the power plug
and secure the appliance from being switched on
again before starting any work.
After completing all work, restore all prerequisites
for start-up.
Maintenance intervals
Components Inspection Cleaning Replacement
Tetra FF Filter Floss Pad – – Monthly
Tetra CF Carbon Filter Me-
dium
– – Every 2 to 4 weeks
Tetra BB Bio Filter Balls Every 12 months In the event of an obstruc-
tion due to extreme soiling
If the dirt on the surface
cannot be removed by rins-
ing
Tetra BF Biological Filter
Foam
Every 6 months When dirt is visible on in-
spection
Every 12 months
Tetra CR Ceramic Filter
Rings
Every 12 months In the event of an obstruc-
tion due to extreme soiling
If the dirt on the surface
cannot be removed by rins-
ing
Impeller – If the motor is not working
or the water flow is reduced
–
To Next Page
Loading...
Need help?
General
