24
English
Emergency Mode
You can send and receive Emergency Group Calls in Trunked
Mode (TMO) or in Direct Mode (DMO). If your terminal is
configured to operate through a gateway, Emergency calls can be
placed through the gateway.
You can initiate an Emergency Group Call to and receive it from the
selected talkgroup (TMO and DMO).
Your Service Provider will configure the Emergency Alarm and Hot
Microphone features.
Emergency calls will be allocated emergency priority in the system.
Entering or Exiting Emergency Mode
To enter Emergency mode from any mode, press and hold the
emergency button at the top of the MTH650.
To exit Emergency mode, press and hold Exit. You will switch to
normal Group mode.
Sending an Emergency Alarm (TMO Only)
Your MTH650 will automatically send an Emergency Alarm when in
Emergency mode. This is sent:
• automatically, upon entering Emergency mode
• if you press the Emergency key again while the MTH650 is in
Emergency mode.
After sending the alarm, the screen will show one of the following
delivery reports:
• Alarm Sent
• Alarm Failed
In both cases the screen returns within a few seconds to the main
screen of the Emergency mode.
The required time you need to press the Emergency button is set to default to
0.5 seconds. The time can be configured by your Service Provider.
For call alerts, see settings in the Vibrate menu option and the Tones menu
option.
6866537D41-A.book Seite 24 Freitag, 5. März 2004 5:14 17