Teuco Hydroline - Automatic Sanitizing (Basic E); Process Initiation and Operation; Sanitizer Level Warning

10min.
AUTOMATIC SANITIZING
(BASIC E)
- Get out of the tub.
- When in standby mode, the panel is lit at low
intensity.
- To start the sanitizing, press the SANITIZE key.
- The sanication process will start, the
SANIFICATION button will light up at high
intensity and the HYDRO button will switch off.
- After 10 minutes, the sanication process will
stop automatically and the panel will return to
stand-by mode.
- To stop the sanitizing process press the SANITIZE
key again.
- The display will go back to standby.
- After these operations, empty the tub.
12
EN
HYDRO BASIC
If the level of the sanication product is low, the SANIFICATION button will ash at high intensity and
low frequency for 30 seconds during the hydromassage start up stage. If the sanitizer is nished, the
SANITIZE key will continue to ash and the sanitizing process will not commence. Press a key to
return to standby and top up the sanitizer (see DIAGNOSTIC MESSAGES).