1
3
2
4
5
1
OK NO
OK NO
REGULAR MAINTENANCE
CLEANING OF SURFACES
See CLEANING INSTRUCTIONS manual
attached.
CLEANING THE HYDRO-MASSAGE JETS
Remove the jet cover (5) using the included tool.
Then, with the aid of the relevant wrench (4),
dismount the jet unit (3), removing its components.
To clean the jets, use an anti-limestone, rinsing
with water.
When reassembling the jet unit (3), be careful that
the gasket (2) is rmly positioned in its seat (1). For
the jet to work properly, reassemble the ring nut,
gently tightening it (do not exert excessive force).
Delicately re-position the cover (5) on the jet,
making sure the plaque fully locks into place all the
way to the limit stop of its centering.
TOPPING UP THE SANITIZER FLUID
(BASIC E)
Open the ller cap for the sanitizer (1) by turning it
anticlockwise.
Pour in the sanitizer uid.
Close the sanitizer ller cap (1) by turning it
clockwise.
14
EN
HYDRO BASIC
To Next Page
Loading...
