Teuco Hydroline - Manual Disinfection; Disinfection Procedure (Basic G); Disinfection Procedure (Basic J); Skipping Sanitization

MANUAL DISINFECTION
BASIC G
- Step out of the tub.
- Add the cleansing uid to the water (20 ml. per
100 litres of water).
- Press the SANITIZE key
- The hydromassage will start.
- The sanication process will stop automatically
after 10 minutes.
- Finally, empty the tub.
BASIC J
- Step out of the tub.
- Check that the water is covering the jets.
- Add the cleansing uid to the water (20 ml. per
100 litres of water).
- Operate the hydromassage function for about
one minute, pressing the HYDRO key.
- Switch off the hydromassage by pressing the
HYDRO key and leave the sanitizer to act inside
the system for about 10 minutes.
- Finally, empty the tub.
TO “AVOID” SANITIZING
If you do not wish to sanitize the system, empty out
the tub.
For another hydromassage, proceed as described
previously.
13
EN
HYDRO BASIC