EN
18
ADD
WATER
ADD
SANITIZER
START
DISINFECTIoN?
DISINFECTION DOES NOT START!!!
tub to the level at which the Disinfection cycle is
able to start.
DISINFECTION DOES NOT START!!!
replenish the dispenser with liquid so that the
Disinfection cycle is able to start. Remove the
Fill the container with Disinfectant so that the
function can start. Replace and secure the
dispenser cap.
20:30
To postpone the disinfection cycle, press the “O/I”
button; the system shuts off and the display reverts
tub.
POSTPONING THE DISINFECTION CYCLE
Display showing
Disinfection prompt
20:30
AUTOMATIC SHUTOFF: If there is no response within 5 seconds when the display prompts START
DISINFECTION?, the system shuts off and the display reverts to STAND-BY. DISINFECTION of the
system is not carried out.
Use only disinfectant solution supplied by Teuco.
To Next Page
Loading...
