EN
17
Press “ENTER” to start the Disinfection.
The display shows a warning message for a few
seconds.
Thereafter, the display indicates Disinfection in
progress.
The disinfection cycle is automatic and includes
the following steps:
whirlpool system operates for 1 minute
from the dispenser;
pause of 10 minutes allowing disinfectant
action;
suction valve closes.
15 36
o
C# 20:30
HEATER oN
15 36
o
C 20:30
HEATER oFF
START
DISINFECTIoN?
LEAVE
BATHTUB
DISINFECTIoN
RUNNING
Whenever the WHIRLPOOL function is activated,
in the bathtub at a steady temperature.
previous item.
The heater switches off, and the display indicates
the “off” status for a few seconds before reverting
to the previous item.
Display showing
Disinfection prompt
DISINFECTION
RUNNING THE DISINFECTION CYCLE
HEATER
AUTOMATIC SHUTOFF: When the function currently selected ceases operating, the heater will also
shut off.
When the system is switched off using the “O/I” button and after at least one whirlpooI cycle has been
selected, a DISINFECTION cycle will follow.
To postpone the disinfection cycle, press the “O/I” button and the display will revert to STAND-BY.
To Next Page
Loading...
