EN
20
The appliance is equipped with various safety features which monitor the operation of the system. In the
event of malfunction, a controller automatically deactivates the function currently in use. The type of error
If the display indicates a fault other than those mentioned in the table, the system needs to be RESET as
follows:
isolate the appliance from the power supply
reconnect power after a few seconds
REPAIRS
DIAGNOSTICS MESSAGES
If any part of the appliance fails to operate as it should, call the nearest Teuco Authorized Service
Centre (see list attached).
If the fault persists, call the nearest Teuco Authorized Service Centre (see list attached).
TROUBLE OR FAULT CAUSE ACTION
Whirlpool system prevented from
in tub.
Fill the tub with water to the minimum
activate.
Disinfection cycle prevented from
dispenser.
Replenish the dispenser with liquid
disinfectant supplied by Teuco.
LOW PRESSURE Clean the suction valve (see
circuit
Call the Help Centre
To Next Page
Loading...
