10 • Universal Subwoofer T6
Setup And Connection
Setup
There are three different ways to
place the subwoofer. Set the ROOM
PLACEMENT switch (6) to the correct
position according to the selected
location.
– Free-standing with the diaphragm
facing sidewards or lying with the
diaphragm facing downwards
(downfire): pos. 1.
– Upright in a corner; the angle
between the diaphragm and the
wall should amount to approx. 45°:
pos. 2.
– Lying under a piece of furniture
with the diaphragm facing down-
wards (downfire): pos. 3.
In the downfire position, the
subwoofer projects the sound waves
directly towards the ground. The
sound waves are directly reflected
and thus produce a uniform signal in
the entire room.
If the subwoofer is in a free-standing
position in the room, the bass
reaches your ear via the shortest
path so it is particularly precise and
crisp.
If you set up the subwoofer in the
corner of a room, make sure to set
the ROOM PLACEMENT switch (6) to
position 2. Otherwise, uncontrollable
frequency rises may occur.
You can find more information in the
Teufel blog at https://blog.teufel.de/
downfire-subwoofer-wenn-der-bass-
den-boden-nutzt/
(2)
• Depending on the type of setup,
stick the isolation pads(2) to the
bottom of the subwoofer or to the
side with the diaphragm.
Connecting
• Insert the small plug of the mains
cord (3) in the input jack(8) and
the big plug in a mains socket
(230 V ~ / 50 Hz). The STATUS LED (4)
pulses in white. If the subwoofer
was already connected to a device,
the connection will be re-estab-
lished. Otherwise, the subwoofer
will automatically switch to pairing
mode.
To Next Page
Loading...
