Teufel T6 - Operation and Status LED; Establishing Wireless Connection; Interpreting Status LED Indicators

11 • Universal Subwoofer T6
Operation
Establish a wireless
connection
Switch your subwoofer and your
wireless-compatible soundbar or
also the subconnect transmitter on.
The STATUS LED (4) will blink and
the devices will now automatically
connect. An existing connection is
indicated by the continuously illumi-
nated STATUS LED (4).
• If the connection is not established
automatically or the connection
is interrupted, push the PAIRING
button (5).
The STATUS LED (4) blinks.
• Perform the corresponding steps
for your soundbar to establish the
connection.
STATUS LED
The STATUS-LED (4) indicates the current operational mode.
STATUS LED Operating mode
Continuously illuminated
in red.
Standby
Continuously illuminated
in white.
Connected and receiving an audio signal.
Pulses in white every
3seconds.
Connected but not receiving any audio signal.
The subwoofer switches to standby after 20
minutes.
Flashes in white twice
every 3seconds.
Subwoofer is on but not connected. The subwoofer
switches to standby after 20 minutes.
Flashes in white quickly. Pairing mode. Device is searching for a compatible
soundbar. After successful pairing, the STATUS
LED is continuously illuminated in white.
Flashes alternating
between red and white.
Subwoofer is reset to the factory default.