Frequently Asked Questions
www.ti.com
26
SPRUII7–June 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
• Does the UART channel wired to the debug probe match the UART channel configured in your
software?
The F28004x LaunchPad provides an option for one of two possible UART channels to be
routed to the debug probe through J101. Ensure that S3, S4, S6, and S8 are configured to the
appropriate UART channel for your application. ,For more information about the Alternate
Routing possibilities, see Section 2.3.
To Next Page
Loading...
