Texas Instruments TI-89 Software Guide

Section 3: Assembler
245
TI
-
89 / TI
-
92 Plus Sierra C Assembler Reference Manual
Not for Distribution
Beta Version February 2, 2001
.line / LINE — Set Line Number Attribute
Syntax
.line
line
LINE
line
Description
line
Specifies the number of the line on which the current symbol is
defined. It is an absolute expression that cannot contain any
forward, external, or undefined references.
The
.line / LINE
directive sets the line number attribute of the symbol referenced
by the current attribute block (see
.def / DEF
directive). For a detailed description
of this attribute, see section
1.4.9 Auxiliary Table Entries
. This directive can
appear at most once per symbol attribute block.
The
.line / LINE
directive is typically used only for C source-level debugging; it is
ignored when assembler source-level debugging information is generated with
the
-L
command line flag (see also
.type / TYPE
directive).
Example
DEF buf
VAL buf
DIM 16,4
SCL 2
TYPE $F4
LINE 25 ; buf is defined on line 25
SIZE 256
ENDEF

Texas Instruments TI-89 Specifications

General

Display size (HxV)	100 x 160 mm
Memory type	639K FLASH ROM, 188K bytes RAM
Compatible operating systems	Operating System 2.09
Battery type	AAA