Texas Instruments TI-99/4A User Reference Guide

UNBREAK
UNBREAK [line-listl
The UN BREAK command is used to remove breakpoints froIll the
program lines listed in the line·Jist. For an explanation of
breakpoints and how they are set, see the BREAK command.
The line'list is a list of line numbers where you want to remove
breakpoints. The line numbers are separated by commas. (For
example: UNBREAK 10,23.) lfyou specify only one line number in
the line·jist, nu CUllllllas are needed.
If you enter an UNBREAK command with no line'list, then all
breakpoints which have been set by a BREAK command or
statement are removed. Note that the UNBREAK command has no
effect on a
BREAK statement with no line·list. The only way to
keep the program from stopping at a BREAK statement with no
line-list is to delete the line
The UNBREAK command may also be used as a statement in a
program. The UNBREAK statement is performed just like the
UNBREAK command, N ate in the example, the UN BREAK
statement removed the breakpoint that was set at 130.
User's Reference Guide
Examples:
>NEW
>100 A=£b.!
>110 C=19.3
>120 PRINT A
>130 PRINT C
~140 END
>BREAK 110,130
>RUN
* BREAKPOINT AT 110
>UNBREAK 130
>CONTINUE
26.7
19 _3
** DONE **
>125 BREAK
>BREAK 100,120,130
>RUN
* BREAKPOINT AT 100
>UNBREAK
>CONTINUE
26.7
* BREAKPOINT AT 125
>CONTINUE
19.3
** DONE **
>BREAK 130
~125 UN13REAK 130
>RUN
26.7
19.3
** DONE **
>125 ENTER
II·33

Texas Instruments TI-99/4A Specifications

General

Brand	Texas Instruments
Model	TI-99/4A
Category	Desktop
Language	English