Texas BC26 - User Manual

Questions and Answers

W
William WilsonJul 30, 2025
Why Texas Brush Cutter engine does not run on full power and smokes heavily?
- J
  Jennifer RosalesJul 30, 2025
  If your Texas Brush Cutter engine doesn't run on full power and smokes heavily, first, make sure you're using the correct fuel mix with new fuel. Also, a dirty air filter could be the cause, so clean or replace it.
J
Jerry KennedyAug 3, 2025
What to do if line cannot be pulled forward on Texas Brush Cutter?
- D
  Dale MillerAug 3, 2025
  If the line on your Texas Brush Cutter cannot be pulled forward, it could be due to several reasons. The line might be melted together because the tool is used too close to stones and walls, so replace it. You can also fit more line, or pull out more line while alternately pressing the line head down and letting go. If the line is entangled, remove the line from the spool and fit it again. Also, try to pull out more line at full speed, if the rotations of the engine are too slow.
D
Desiree GardnerAug 8, 2025
Why grass is wrapped around the gear head or line head of Texas Brush Cutter?
- S
  Stephen RandallAug 8, 2025
  If grass is wrapping around the gear head or line head of your Texas Brush Cutter, it's likely because you're cutting tall grass at the base. Try cutting the grass from the top downwards. Also, ensure the trimmer is used at full speed.
A
Anita WilliamsAug 12, 2025
What to do if Texas Brush Cutter engine is drowned?
- Y
  yproctorAug 12, 2025
  If your Texas Brush Cutter engine does not start, and you suspect it's 'drowned', remove the spark plug and turn the trimmer so the spark plug hole faces down. Set the choke to 'RUN' and pull the starter 10-15 times. Clean and refit the spark plug, or replace it. Then, pull the starter 3 times with the choke on 'RUN'. If it still fails, switch the choke to 'Choke' and use the normal starting procedure. If needed, repeat with a new spark plug.
E
Eric MejiaAug 16, 2025
Why oil leaks from the exhaust of Texas Brush Cutter?
- L
  lauraburnettAug 16, 2025
  If oil leaks from the exhaust of your Texas Brush Cutter, try using the trimmer on full power. Also, check the fuel mix and use new fuel with the correct two-stroke mix. Another cause may be a dirty air filter, so clean or replace it.
S
smithstephenAug 21, 2025
Why spool head is difficult to turn on Texas Brush Cutter?
- K
  Kim LeeAug 21, 2025
  If the spool head on your Texas Brush Cutter is difficult to turn, the threads might be dirty, damaged, or full of grass. Clean the threads and grease or change the spool head. Also, remove any grass.
R
Robert JohnsonAug 26, 2025
What causes Texas Brush Cutter to start, run, and accelerate but cannot run idle?
- J
  Jonathan DayAug 26, 2025
  If the engine starts, runs, and accelerates but cannot run idle on your Texas Brush Cutter, the carburetor needs adjustment.