the engine must be STOPPED, the spark plug cap taken off and the grass then
removed.
For moving the line forward you tap the trimmer head lightly against the ground
while the engine runs at full speed.
Hold the trimmer at an angle towards the area that is to be cut.
The illustration shows the best cutting angle (Fig6).
Use the line to cut. Do not force the trimmer head into grass that has not yet been
cut.
Wire and fences are hard on the line and may even cause it to break.
Stones and walls, and wood cause the line to be worn down very fast. Walk around
trees and bushes. Bark and trees, wood boarding and poles are easily damaged by
the line.
Start / Stop.
How to start a cold engine
1. Place the brush cutter on a flat surface.
2. Switch to ”Start”. Fig5b
3. Press 8-10 times on the fuel pump located beneath the air filter. Fig5a
4. Switch the choke to on
5. Activate the safety handle and press the throttle control, then lock the handle with
the locking pawl. Fig.5b
6. Pull the starter until the engine runs.
7. Slide the choke lever to off position when the engine starts to be warm.
How to start a warm engine
1. Switch the choke to off
2. Pull the recoil starter until the engine runs.
How to stop the engine
1. Release the gas and the safety switch. Fig.5b
2. Press the Stop-switch” in/up.
10. Fuel
This product is equipped with a two-stroke engine that demands two-stroke oil
added to the petrol.
Always use unleaded gasoline.
Never use ready-mixed gasoline/oil from service stations that is normally used for
mopeds, motorbikes, etc.
Always follow the directions of the supplier for the oil regarding the mix of oil (see
the back of the oil container).
Use a clean and approved petrol can for mixing the petrol with oil.
Use an approved two-stroke oil for air cooled engines, chainsaws, trimmers etc. (Do
not use oil for out board engines of cars. (Mix only small quantities).
Normally 2% oil is mixed with the gasoline. (50:1) However, always follow the
directions of the manufacturer of the oil.
Mix the oil and gasoline thoroughly and shake the can before filling.
Never use a mix of gasoline and oil that is more than 90 days old as this may lead
to problems when starting the engine. Never store the same mixture in the tank for
more than 30 days.
To Next Page
Loading...