The engine does not
start.
Check the spark plug. Take off the spark
plug, place the spark plug cap on the spark
plug and place the spark plug on the metal
cylinder. Pull she starter and check if there
are sparks on the top of the spark plug. If
there are no sparks repeat procedure with a
new spark plug. If still no sparks contact
local dealer.
Press the fuel primer. If the problem
persists, contact your local dealer.
Remove the spark plug and turn the
trimmer so that the spark plug hole faces
the ground. Switch the choke to “RUN” and
pull the starter 10-15 times. Clean the spark
plug and fit it again. You may also replace
the spark plug. Pull the starter 3 times with
the choke switched to “RUN”. If the engine
does not start, move the choke to “Choke”
and normal starting procedure is used. If
the engine still does not start, repeat the
procedure with a new spark plug.
4. The starter must be
pulled harder than when
the machine was new.
Contact your local dealer.
The engine starts but
does not accelerate.
The carburetor needs
adjustment.
Contact your local dealer.
The engine starts but
can only run on full
power and on half
choke
The carburetor must be
adjusted, repaired or
cleaned.
Contact your local dealer.
The engine does not
run on full power and
smokes heavily.
1. Check the mix of the
fuel.
Use new fuel with the correct mix.
2. The air filter is dirty
3. The carburetor needs
adjustment.
Contact your local dealer.
The engine starts,
runs, and accelerates
but
Cannot run idle.
The carburetor needs
adjustment.
Contact your local dealer.
The line cannot be
pulled forward.
1. The line is melted
together.
Replace. You may be using the tool too
close to stones and walls.
3. The line is worn short.
Pull out more line while alternately pressing
the line head down and letting go.
4. The line is entangled.
Remove the line from the spool and fit it
again.
5. The rotations of the
engine are too slow.
Pull out more line at full speed.
To Next Page
Loading...