Texas BCX 370 - User Manual

Questions and Answers

B
Brendan WeaverAug 17, 2025
Why is oil dripping from the exhaust of my Texas Trimmer?
- H
  Hannah GrayAug 17, 2025
  If you notice oil dripping from the exhaust of your Texas Trimmer, here are a few possible causes and solutions: * **Low RPM:** Ensure you are using the trimmer at high RPM. * **Incorrect fuel mix:** Use new fuel with the correct 2-stroke mix. * **Dirty air filter:** Clean or replace the air filter. * **Carburetor issues:** The carburetor may need adjustment, which might require professional assistance.
T
Tracy GonzalezAug 20, 2025
What to do if my Texas BCX 370 Trimmer engine will not reach full speed and produces a lot of smoke?
- B
  Billy GregoryAug 21, 2025
  If your Texas Trimmer engine won't reach full speed and is producing a lot of smoke, consider the following: * **Fuel mix ratio:** Use new fuel with the correct mix ratio. * **Air filter:** The air filter may be dirty, so clean or replace it. If this doesn't resolve the issue, the carburetor might need adjustment, which may require professional assistance.
C
Crystal RomeroAug 25, 2025
What to do if grass getting twisted around drive shaft and twine housing of Texas BCX 370?
- D
  David RodriguezAug 25, 2025
  If grass is getting twisted around the drive shaft and twine housing of your Texas Trimmer: * **Cutting technique:** If you are cutting high grass at ground level, try cutting the grass from the top down. * **RPM:** Ensure the trimmer is used at high RPM.
M
Michael LopezAug 27, 2025
What to do if twine cannot be extended on my Texas BCX 370?
- G
  grahamlindaAug 27, 2025
  If the twine cannot be extended on your Texas Trimmer, here are some things to check: * **Melted twine:** Replace the twine. * **Insufficient twine:** Fit more twine onto the spool. * **Worn twine:** Advance the twine while alternatively pressing and releasing the twine housing. * **Tangled twine:** Remove the twine from the spool and roll it on again. * **Low engine RPM:** Advance the twine at full throttle.
J
Jordan DurhamAug 30, 2025
What to do if my Texas BCX 370 Trimmer engine starts, but will not accelerate?
- S
  Susan Reyes MDAug 30, 2025
  If your Texas Trimmer engine starts but will not accelerate, the carburetor may need adjustment, which may require professional assistance.
J
Jessica MccoySep 3, 2025
What to do if my Texas BCX 370 Trimmer engine starts, but will only run at full throttle with half choke?
- J
  jasonmoonSep 3, 2025
  If your Texas Trimmer engine starts but will only run at full throttle with half choke, the carburetor may need adjustment, repair, or cleaning, which may require professional assistance.
M
Mary DonaldsonSep 6, 2025
What to do if my Texas Trimmer engine starts, runs and accelerates, but will not run in idle?
- D
  Daniel ReynoldsSep 6, 2025
  If your Texas Trimmer engine starts, runs, and accelerates, but will not run in idle, the carburetor may need adjustment, which may require professional assistance.
A
alexisjohnsonSep 9, 2025
Why is the twine spool hard to turn on my Texas BCX 370 Trimmer?
- K
  Kaitlyn WilkersonSep 9, 2025
  If the twine spool is hard to turn on your Texas Trimmer, it could be due to dirty, damaged, or grass-filled threads. Try cleaning the threads and lubricating them with grease. If the problem persists, consider replacing the spool.
T
torrestracyNov 13, 2025
What to do if my Texas Trimmer engine will not start?
- A
  alexandrafrostNov 13, 2025
  If your Texas Trimmer engine won't start, there could be several reasons: * **No spark:** Check the spark plug. Remove it, connect the lead, and place the plug on the cylinder block. Pull the starter cord to check for a spark. If there's no spark, repeat with a new spark plug. * **No fuel:** Press the fuel pump button. If the problem continues, it may require professional attention. * **Engine flooded:** Remove the spark plug and turn the trimmer over, pointing the spark plug hole downwards. Set the choke to "Run" and pull the starter cord 10-15 times. Clean the spark plug and replace it. If necessary, renew the spark plug. Pull the starter cord three times with the choke set to "Run". If it still fails, set the choke to "Choke" and perform the normal start procedure. If the engine ...