EasyManua.ls Logo

Texas BCX 320 - User Manual

Texas BCX 320
85 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
BCX260 - BCX 300 - BCX 320
BCX370 - BCX430
DK Betjeningsvejledning
GB User manual
D Bedienungsanleitung
F Manuel D‘ Utilisation
S Bruksanvisning
RU Руководство пользователя
PL Instrukcja obsługi
CZ Návod k použití
Texas A/S - Knullen 22 - DK-5260 Odense S - Denmark Vers 12.1
Tel. +45 6395 5555 - www.texas.dk - post@texas.dk

Table of Contents

Questions and Answers

  • N
    nortizAug 18, 2025
    Why is oil dripping from the exhaust of my Texas Trimmer?
    • T
      Timothy BrewerAug 18, 2025
      If you notice oil dripping from the exhaust of your Texas Trimmer, here are a few possible causes and solutions: * **Low RPM:** Ensure you are using the trimmer at high RPM. * **Incorrect fuel mix:** Use new fuel with the correct 2-stroke mix. * **Dirty air filter:** Clean or replace the air filter. * **Carburetor issues:** The carburetor may need adjustment, which might require professional assistance.
  • A
    Ann HermanAug 21, 2025
    What to do if my Texas BCX 320 engine will not reach full speed and produces a lot of smoke?
    • J
      John HensonAug 21, 2025
      If your Texas Trimmer engine won't reach full speed and is producing a lot of smoke, consider the following: * **Fuel mix ratio:** Use new fuel with the correct mix ratio. * **Air filter:** The air filter may be dirty, so clean or replace it. If this doesn't resolve the issue, the carburetor might need adjustment, which may require professional assistance.
  • J
    Johnny HernandezAug 26, 2025
    What to do if grass getting twisted around drive shaft and twine housing of Texas Trimmer?
    • A
      Amber FowlerAug 26, 2025
      If grass is getting twisted around the drive shaft and twine housing of your Texas Trimmer: * **Cutting technique:** If you are cutting high grass at ground level, try cutting the grass from the top down. * **RPM:** Ensure the trimmer is used at high RPM.
  • P
    Pam GarciaAug 28, 2025
    What to do if twine cannot be extended on my Texas BCX 320?
    • J
      Jessica WestAug 29, 2025
      If the twine cannot be extended on your Texas Trimmer, here are some things to check: * **Melted twine:** Replace the twine. * **Insufficient twine:** Fit more twine onto the spool. * **Worn twine:** Advance the twine while alternatively pressing and releasing the twine housing. * **Tangled twine:** Remove the twine from the spool and roll it on again. * **Low engine RPM:** Advance the twine at full throttle.
  • K
    Katelyn WilliamsAug 31, 2025
    What to do if my Texas BCX 320 engine starts, but will not accelerate?
    • G
      gregory85Aug 31, 2025
      If your Texas Trimmer engine starts but will not accelerate, the carburetor may need adjustment, which may require professional assistance.
  • M
    Michael CooperSep 4, 2025
    What to do if my Texas BCX 320 Trimmer engine starts, but will only run at full throttle with half choke?
    • M
      Michelle JohnsonSep 4, 2025
      If your Texas Trimmer engine starts but will only run at full throttle with half choke, the carburetor may need adjustment, repair, or cleaning, which may require professional assistance.
  • F
    frobinsonSep 8, 2025
    What to do if my Texas Trimmer engine starts, runs and accelerates, but will not run in idle?
    • G
      Gregory SwansonSep 8, 2025
      If your Texas Trimmer engine starts, runs, and accelerates, but will not run in idle, the carburetor may need adjustment, which may require professional assistance.
  • K
    Katie NicholsSep 12, 2025
    Why is the twine spool hard to turn on my Texas BCX 320 Trimmer?
    • D
      david87Sep 12, 2025
      If the twine spool is hard to turn on your Texas Trimmer, it could be due to dirty, damaged, or grass-filled threads. Try cleaning the threads and lubricating them with grease. If the problem persists, consider replacing the spool.
  • S
    Sean WardNov 14, 2025
    What to do if my Texas BCX 320 Trimmer engine will not start?
    • J
      Jessica SheltonNov 14, 2025
      If your Texas Trimmer engine won't start, there could be several reasons: * **No spark:** Check the spark plug. Remove it, connect the lead, and place the plug on the cylinder block. Pull the starter cord to check for a spark. If there's no spark, repeat with a new spark plug. * **No fuel:** Press the fuel pump button. If the problem continues, it may require professional attention. * **Engine flooded:** Remove the spark plug and turn the trimmer over, pointing the spark plug hole downwards. Set the choke to "Run" and pull the starter cord 10-15 times. Clean the spark plug and replace it. If necessary, renew the spark plug. Pull the starter cord three times with the choke set to "Run". If it still fails, set the choke to "Choke" and perform the normal start procedure. If the engine ...

Summary

Identification of Symbols and Safety Instructions

General Safety and Warnings

Operating Restrictions and Precautions

Details restrictions on use, user age, environment, and preparation of the work area.

Mode Switching and Blade Operation

Twine Replacement Procedure

Fueling and Fuel Mixture

Starting and Stopping the Engine

Cold Engine Start Procedure

Detailed steps for initiating the engine from a cold state, including choke and throttle use.

Warm Engine Start Procedure

Instructions for starting the engine when it is already warm, simplifying the process.

Engine Stopping Procedure

Simple steps to safely shut down the engine after operation.

Operating the Trimmer and Bush Clearer

Trimmer Operation Techniques

Guidance on using the trimmer effectively, including twine feed and cutting angles.

Bush Clearer Operation Techniques

Instructions for operating the bush clearer, specifying cutting direction and zone.

Troubleshooting Guide

Product Specifications

Texas BCX 320 Specifications

General IconGeneral
BrandTexas
ModelBCX 320
CategoryTrimmer
LanguageEnglish

Related product manuals