Why Texas BCU26S engine does not run on full power and smokes heavily?
If your Texas Trimmer engine doesn't run on full power and smokes heavily, check the fuel mix and ensure you are using new fuel with the correct mix. Also, the air filter may be dirty, so clean or replace it. If the problem persists, the carburetor might need adjustment, and you should contact your local dealer.
What to do if the line cannot be pulled forward on Texas BCU26S Trimmer?
If the line on your Texas Trimmer cannot be pulled forward, it might be due to several reasons: * The line is melted together: Replace the line. Avoid using the tool too close to stones and walls. * Too little line: Fit more line. * The line is worn short: Pull out more line while alternately pressing the line head down and letting go. * The line is entangled: Remove the line from the spool and fit it again. * The engine rotations are too slow: Pull out more line at full speed.
Why is oil leaking from the exhaust of my Texas Trimmer?
If oil leaks from the exhaust of your Texas Trimmer, try the following: * Ensure the trimmer is used on full power. * Check the fuel mix and use new fuel with the correct two-stroke mix. * Clean or replace the air filter. If the issue continues, the carburetor may need adjustment, and you should contact your local dealer.
How to prevent grass from wrapping around the gear head of my Texas Trimmer?
If grass is wrapping around the gear head or line head of your Texas Trimmer, it may be because tall grass is cut at the base. To resolve this, cut the grass from the top and downwards. Also, ensure the trimmer is used at full speed.
What to do if Texas Trimmer engine starts but does not accelerate?
If your Texas Trimmer engine starts but does not accelerate, the carburetor may need adjustment. Contact your local dealer for assistance.
Why Texas BCU26S engine starts but can only run on full power and on half choke?
If your Texas Trimmer engine starts but can only run on full power and on half choke, the carburetor likely needs adjustment, repair, or cleaning. Contact your local dealer for assistance.
What to do if Texas BCU26S engine starts but Cannot run idle?
If your Texas Trimmer engine starts, runs, and accelerates but cannot run idle, the carburetor likely needs adjustment. Contact your local dealer for assistance.
Why is the spool head difficult to turn on my Texas BCU26S?
If the spool head on your Texas Trimmer is difficult to turn, it's likely because the threads are dirty, damaged, or full of grass. Clean the threads and grease or change the spool head. Remove any grass.
What to do if my Texas BCU26S engine does not start?
If your Texas Trimmer engine doesn't start, there could be several reasons: * No spark: Inspect the spark plug by removing it, placing the spark plug cap on it, and positioning it against the metal cylinder. Pull the starter to check for sparks. If none, try a new spark plug. If still no sparks, contact your local dealer. * No fuel: Press the fuel primer. If that doesn't work, contact your local dealer. * “Drowned” engine: Remove the spark plug and turn the trimmer so that the spark plug hole faces the ground. Switch the choke to “RUN” and pull the starter 10-15 times. Clean the spark plug and fit it again or replace it. Pull the starter 3 times with the choke switched to “RUN”. If the engine does not start, move the choke to “Choke” and normal starting procedure is used. If the eng...
General| Power Source | Battery |
|---|---|
| Voltage | 26 V |
| Cutting Width | 30 cm |
| Type | String Trimmer |
| Battery Type | Lithium-ion |
| Runtime | 30 minutes |
To Next Page
