EasyManua.ls Logo

Texas BC 335-4 - User Manual

Texas BC 335-4
47 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
BC 335-4
10.1
DK Betjeningsvejledning
GB User manual
DE Bedienungsanleitung
FR Manuel d'utilisation
Texas A/S - Knullen 22 - DK-5260 Odense S - Denmark
Tel. +45 6395 5555 - www.texas.dk - post@texas.dk

Table of Contents

Other manuals for Texas BC 335-4

Preview: Original Instructions
Original Instructions69 pages

Questions and Answers

  • D
    David FullerAug 20, 2025
    What to do if my Texas BC 335-4 engine will not start?
    • C
      Cindy ClarkAug 20, 2025
      First, check the spark plug for a spark by removing it, connecting the lead, and placing it on the cylinder block while pulling the starter cord. If there's no spark, try a new spark plug. Also, ensure the engine isn't flooded by removing the spark plug, turning the trimmer over with the spark plug hole facing down, setting the choke to 'Run,' and pulling the starter cord 10-15 times. Clean or replace the spark plug. If there's still no start, press the fuel pump button. If the problem continues, it may require professional attention.
  • B
    Brandon ObrienAug 22, 2025
    Why does my Texas BC 335-4 engine start, but will not reach full speed and produces a lot of smoke?
    • H
      Haley WilsonAug 22, 2025
      This could be due to several reasons. Begin by using new fuel. If that doesn't resolve the issue, check the air filter; it may be dirty and require cleaning or replacement. If the problem persists after these steps, the carburetor may need adjustment, which requires professional assistance.
  • L
    Lisa ShawAug 25, 2025
    Why is my Texas Trimmer cord not extending?
    • N
      Nicole AbbottAug 25, 2025
      There are several possible reasons why the cord isn't extending. The cord may be melted, worn down, or tangled on the spool, in which case you should replace the cord or remove it and roll it back on the spool. Ensure there is sufficient cord on the spool; if not, fit more cord. If the engine RPM is too low, advance the cord while pressing and releasing the cord housing. Alternatively, try advancing the cord at full throttle.
  • T
    talvarezAug 27, 2025
    What to do if my Texas BC 335-4 Trimmer engine starts, but will not accelerate?
    • L
      Lisa CaldwellAug 27, 2025
      If the engine starts but won't accelerate, the carburetor likely needs adjustment, which is a job for a qualified repair shop.
  • K
    Kelsey ReynoldsAug 28, 2025
    What to do if my Texas BC 335-4 engine starts, but will only run at full throttle with half choke?
    • P
      Patricia JohnsonAug 28, 2025
      This issue typically indicates that the carburetor needs adjustment, repair, or cleaning, which requires assistance from a repair shop.
  • H
    hessmeganAug 30, 2025
    Why is grass getting twisted around the drive shaft and cord housing of my Texas Trimmer?
    • D
      Destiny HowardAug 30, 2025
      This issue often occurs when cutting high grass at ground level; try cutting the grass from the top down instead. Also, ensure the trimmer is used at high RPM, as using it at low RPM can cause this problem.
  • S
    Samantha JensenAug 31, 2025
    What to do if my Texas Trimmer engine starts, runs and accelerates, but will not run in idle?
    • B
      Becky MasseyAug 31, 2025
      If the engine starts, runs, and accelerates but won't idle, the carburetor likely needs adjustment, which requires professional assistance from a repair shop.
  • S
    Shawn RitterSep 2, 2025
    Why is the cord spool hard to turn on my Texas BC 335-4 Trimmer?
    • L
      lwhiteSep 2, 2025
      If the cord spool is hard to turn, it's likely due to dirty, damaged, or grass-filled threads. Clean the threads and lubricate them with grease. If necessary, replace the spool.
  • D
    David ScottSep 4, 2025
    Why Texas BC 335-4 Trimmer engine will not start?
    • A
      Alexandria RangelSep 4, 2025
      If the Texas Trimmer engine won't start, there could be several reasons. First, check the spark plug for a spark by removing it, connecting the lead, and placing it on the cylinder block, then pull the starter cord; replace the spark plug if there is no spark. Second, ensure the engine is getting fuel by pressing the fuel pump button; if the problem continues, contact a dealer or repair shop. Third, if the engine is flooded, remove the spark plug, turn the trimmer over with the spark plug hole facing down, set the choke to 'Run,' and pull the starter cord 10–15 times, then clean and replace the spark plug if needed; if it still fails, repeat with a new spark plug. Finally, if the starter cord is harder to pull than usual, contact a dealer or repair shop.
  • T
    Tamara FernandezSep 6, 2025
    What to do if Texas BC 335-4 Trimmer engine will not reach full speed and produces a lot of smoke?
    • V
      Vanessa BoydSep 6, 2025
      If your Texas Trimmer engine won't reach full speed and produces a lot of smoke, first, use new fuel. Second, the air filter may be dirty, so clean or replace it; you may need to contact a repair shop. Third, the carburetor might need adjustment, so contact a repair shop.

Summary

Identification of Symbols and Safety Instructions

Identification of Parts

Switch from Trimmer to Brushcutter

Using the Blade

Guidance on safe and effective operation with the blade.

Switch from Brushcutter to Trimmer

Replacing Cord

Fuel

Oil

Start;Stop

Starting a Cold Engine

Starting a Warm Engine

Stopping Engine

Operation

Trimmer Operation

How to use the machine as a trimmer.

Brushcutter Operation

How to use the machine as a brushcutter.

Troubleshooting

Texas BC 335-4 Specifications

General IconGeneral
BrandTexas
ModelBC 335-4
CategoryTrimmer
LanguageEnglish

Related product manuals