To Next PageTo Next PageWhat to do if Texas CG230B engine does not run on full power and smokes heavily?
If your Texas Grass trimmer engine lacks full power and smokes a lot, check the fuel mix and use new fuel with the correct mix. Another possible reason is that the air filter is dirty, so you should clean or replace it. It may also be necessary to contact your local dealer for carburetor adjustment.
Why is oil leaking from the exhaust of my Texas CG230B Grass trimmer?
If oil leaks from the exhaust of your Texas Grass trimmer, it could be due to several reasons. Ensure you are using the trimmer at full power. Also, check the fuel mix and use new fuel with the correct two-stroke mix. Another cause might be a dirty air filter, so clean or replace it. If the problem persists, the carburetor may need adjustment, and you should contact your local dealer.
How to fix Texas CG230B when engine starts but does not accelerate?
If your Texas Grass trimmer starts but won't accelerate, the carburetor likely needs adjustment. Contact your local dealer to handle this.
Why Texas CG230B engine starts but can only run on full power and on half choke?
If your Texas Grass trimmer engine starts but only runs on full power and half choke, the carburetor likely needs adjustment, repair, or cleaning. Contact your local dealer for assistance.
What to do if Texas CG230B Grass trimmer engine starts, runs, and accelerates but cannot run idle?
If the engine of your Texas Grass trimmer starts, runs, and accelerates but cannot run idle, the carburetor likely needs adjustment. Contact your local dealer.
How to prevent grass from wrapping around the gear head of my Texas CG230B?
If grass is wrapping around the gear head or line head of your Texas Grass trimmer, it may be because tall grass is being cut at the base. Try cutting the grass from the top downwards. Also, ensure the trimmer is used at full speed.
Why the line of my Texas CG230B cannot be pulled forward?
If the line of your Texas Grass trimmer cannot be pulled forward, it could be because the line is melted together. Replace the line, and consider that you may be using the tool too close to stones and walls. Another reason might be that there is too little line, so fit more line.
What causes the spool head of my Texas Grass trimmer to be difficult to turn?
If the spool head of your Texas Grass trimmer is difficult to turn, the threads might be dirty, damaged, or full of grass. Clean the threads, grease or change the spool head, and remove any grass.
Why my Texas Lawn and Garden Equipment engine does not start?
If your Texas Lawn and Garden Equipment engine isn't starting, there could be several reasons. First, check the spark plug; if there are no sparks, try a new one. If that doesn't work, contact your local dealer. Another possibility is no fuel; try pressing the fuel primer. If the issue remains, contact your local dealer. Also, the engine might be drowned; in this case, remove the spark plug, turn the trimmer so the spark plug hole faces the ground, switch the choke to RUN, and pull the starter 10-15 times. Clean and refit the spark plug or replace it. Finally, if the starter is harder to pull than usual, contact your local dealer.
What to do if my Texas Lawn and Garden Equipment engine does not run on full power and smokes heavily?
If your Texas Lawn and Garden Equipment engine isn't running on full power and is smoking heavily, start by checking the fuel mix and ensure you are using new fuel with the correct mix. Also, inspect the air filter; it may need cleaning or replacing. If these steps don't resolve the issue, the carburetor may need adjustment, and you should contact your local dealer.
General| Engine Type | 2-stroke |
|---|---|
| Engine Displacement | 25.4 cc |
| Shaft Type | Straight |
| Power source | Gasoline |
| Fuel Tank Capacity | 0.6 L |
Details warning symbols, safety rules, and personal injury prevention measures.
Steps for detaching the trimmer head and installing the cutting blade.
Guidelines for using the blade safely and effectively.
Steps for removing the blade and installing the trimmer head.
Information on correct fuel-to-oil ratio, storage, and handling.
Critical safety rules to follow when refueling the machine.
Detailed steps for starting the engine from a cold state.
Instructions for safely shutting down the engine.
Guidance on proper usage, cutting techniques, and line extension.
Procedures for cleaning or replacing the air filter for optimal performance.
