Texas GTX 300 User Manual (English)

Questions and Answers:

C
Curtis CabreraAug 7, 2025
What to do if the Trimmer string cannot be pulled ahead on my Texas Trimmer?
- D
  douglasdaughertyAug 7, 2025
  If your Texas Trimmer string cannot be pulled ahead, it might be due to several reasons. The string may have melted together, possibly from cutting too close to rocks and walls – in this case, replace the string. Another reason could be that there's not enough string on the spool, so install more string. The string might also be worn short, in which case you should pull the string out while alternatingly pushing and releasing the string housing. Also, the string may have become twisted or tangled on the spool, so take the string off the spool and wind it back on. Finally, the engine RPM might be too low, so advance the string at full throttle.
B
Brett ReedAug 12, 2025
Why does my Texas GTX 300 engine lack full speed and emit smoke?
- J
  justin96Aug 12, 2025
  If your Texas Trimmer engine does not attain full speed and emits a lot of smoke, it could be due to a few reasons. First, check the fuel mixing ratio and use new fuel with the correct ratio. Additionally, a dirty air filter can cause this issue, so clean or replace it.
A
Amanda JonesAug 16, 2025
Why does grass get wrapped around the drive shaft housing and string housing of my Texas GTX 300 Trimmer?
- B
  brenda36Aug 17, 2025
  If grass gets wrapped around the drive shaft housing and string housing of your Texas Trimmer, it's likely because you are cutting tall grass at ground level, so cut tall grass from the top down. Also, ensure that the trimmer is being used at full throttle.
M
Mackenzie JonesAug 21, 2025
Why is oil dripping from the exhaust of my Texas GTX 300 Trimmer?
- M
  Michele LewisAug 21, 2025
  If oil is dripping from the exhaust of your Texas Trimmer, make sure you are using the trimmer at full throttle. Also, check the fuel mixing ratio and use new fuel with the correct 2 stroke mixture. A dirty air filter can also cause this, so clean or replace it.
K
Kathryn PaulAug 27, 2025
How to fix a spool canister that is difficult to turn on a Texas GTX 300 Trimmer?
- B
  Bradley HaleAug 27, 2025
  If the spool canister on your Texas Trimmer is difficult to turn, the threads may be dirty, damaged, or full of grass. Clean the threads and grease them, and clean out any grass. If that's not enough, replace the spool with a new one.
A
Amanda HigginsAug 31, 2025
What to do if Texas Trimmer starts but only runs at full throttle on half choke?
- P
  psinghSep 1, 2025
  If your Texas Trimmer engine starts but only runs at full throttle on half choke, the carburetor likely needs adjustment, repair, or cleaning.