Why does my Texas Trimmer engine not run on full power and smokes heavily?
If your Texas Trimmer engine lacks full power and smokes a lot, examine the fuel mix and ensure it's correct and fresh. A dirty air filter could also be the cause, so clean or replace it.
What to do if the line can not be pulled forward on my Texas GT261?
If the line on your Texas Trimmer won't pull forward, it could be due to several reasons. The line might be melted together, in which case you should replace it. Remember that using the tool too close to stones and walls may cause this. It could also be caused by too little line, so fit more line. Another reason might be that the line is worn short; try pulling out more line while pressing the line head down and letting go alternately. Alternatively, the line could be entangled, so remove it from the spool and fit it again. Finally, the engine rotations might be too slow; try pulling out more line at full speed.
Why is oil leaking from the exhaust of my Texas GT261 Trimmer?
If oil leaks from the exhaust of your Texas Trimmer, ensure you are using it at full power. Also, check the fuel mix; use new fuel with the correct two-stroke mix. A dirty air filter can also cause this, so clean or replace it.
Why is the spool head difficult to turn on my Texas Trimmer?
If the spool head on your Texas Trimmer is hard to turn, the threads might be dirty, damaged, or full of grass. Clean the threads, grease or change the spool head, and remove any grass.
What to do if my Texas GT261 engine does not start?
If your Texas Trimmer's engine won't start, there could be several reasons. It might be due to no spark. Check the spark plug by removing it, placing the spark plug cap on it, and putting the spark plug on the metal cylinder. Pull the starter to see if there are sparks. If not, try a new spark plug. Another reason could be no fuel. Try pressing the fuel primer. Also, the engine might be drowned. Remove the spark plug, turn the trimmer so the spark plug hole faces down, switch the choke to “RUN,” and pull the starter 10-15 times. Clean the spark plug and refit it, or replace it. Then, pull the starter 3 times with the choke on “RUN.” If it still doesn’t start, move the choke to “Choke” and use the normal starting procedure. If problems persist with starting, repeat the procedure with a new ...
Step-by-step guide for starting a cold engine on the trimmer.
Procedure for starting the trimmer when the engine is already warm.
Instructions on how to safely shut down the trimmer's engine.
To Next Page
General
