www.texas.dk
30
Fit the spring below the spool and mount it by pressing it against the spindle. Pull the ends
of the line hard to avoid them from locking in the eyelids.
Fit the bumper head knob. Use 4 mm nylon line.
10. Air filter
For correct performance and durability the air filter must be kept clean.
1. Remove the lid of the air filter by unscrewing the screw that fastens the lid.
2. Wash the filter in mild soap water. Leave it to dry. Pour on a little two-stroke oil
Press out any surplus oil. Replace an old and worn filter.
3. Filter and lid is fitted again. Make sure that the filter and lid is secured tightened.
Clean the air filter for every 5 hours or more often if you work in dusty areas.
11. Spark plug
This machine is equipped with a spark plug type Denso W22MPR-U with an electrode
distance of 0,6 mm. For optimal performance it should be replaced once a year.
Spare part number for sparkplug: 10011022.
12. Storage
1. Empty all fuel into a can approved for petrol. Let the engine run until it stops.
2. Clean the head, and store the machine frost free and out of reach for children.
3. Observe all safety precautions concerning safe storage and handling of gasoline.
To Next Page
Loading...
