Why Texas Trimmer engine does not run on full power and smokes heavily?
If your Texas Trimmer engine lacks full power and smokes heavily, start by checking the fuel mix and ensure you are using new fuel with the correct mix. Also, the air filter might be dirty, so clean or replace it. If these steps don't resolve the issue, the carburetor may need adjustment, and you should contact your local dealer.
What to do if Texas CG 250 E Trimmer has oil leaks from the exhaust?
If oil is leaking from the exhaust of your Texas Trimmer, ensure the trimmer is used on full power. Also, verify the fuel mix and use new fuel with the correct two-stroke mix. Check if the air filter is dirty, and clean or replace it if needed. If the problem persists, the carburetor may require adjustment; contact your local dealer.
Why the line can not be pulled forward on my Texas CG 250 E Trimmer?
If the line on your Texas Trimmer won't pull forward, the line might be melted together (replace it, and avoid using the tool too close to stones and walls), or there might be too little line (fit more line). The line could also be worn short (pull out more line while pressing the line head down and letting go), or the line is entangled (remove the line from the spool and fit it again). Also, ensure the engine rotations aren't too slow (pull out more line at full speed).
What to do if Texas Trimmer engine starts but does not accelerate?
If your Texas Trimmer starts but doesn't accelerate, the carburetor likely needs adjustment, so contact your local dealer.
How to prevent grass from wrapping around the head of Texas Trimmer?
If grass is wrapping around the gear head or line head of your Texas Trimmer, it might be because tall grass is being cut at the base; try cutting the grass from the top downwards. Also, ensure the trimmer is used at full speed.
What to do if Texas CG 250 E Trimmer starts but can only run on full power and on half choke?
If your Texas Trimmer engine starts but only runs on full power and half choke, the carburetor likely needs adjustment, repair, or cleaning. Contact your local dealer.
What to do if Texas CG 250 E Trimmer starts, runs, and accelerates but can not run idle?
If the engine of your Texas Trimmer starts, runs, and accelerates but cannot run idle, the carburetor likely needs adjustment, so contact your local dealer.
Why Texas Trimmer spool head is difficult to turn?
If the spool head on your Texas Trimmer is difficult to turn, the threads may be dirty, damaged, or full of grass. Clean the threads and grease or change the spool head, also remove any grass.
How to fix Texas CG 250 E Trimmer when the engine does not start?
If your Texas Trimmer's engine won't start, there could be several reasons. First, check the spark plug for sparks by removing it, placing it on the metal cylinder with the spark plug cap on, and pulling the starter. If there are no sparks, try a new spark plug. If the issue continues, contact your local dealer. Another reason could be lack of fuel, try pressing the fuel primer. If that doesn't work, contact your local dealer. The engine might also be drowned; in that case, remove the spark plug, turn the trimmer so the spark plug hole faces down, switch the choke to RUN, and pull the starter 10-15 times. Clean and refit the spark plug, or replace it. Pull the starter 3 times with the choke on RUN. If it still fails, switch the choke to Choke and use the normal starting procedure. If probl...
To Next Page
General
