Texas CG 250 E - Operation; Replacement of Cord

www.texas.dk
26
7. Operation
- High grass should always be cut from the top and downwards. In this way you
prevent the grass from being wrapped around the trimmer head and thereby lead to
over heating and damage. If grass and the like is wrapped around the trimmer head
the engine must be STOPPED, the spark plug cap taken off and the grass then
removed.
Trimming technique
- For moving the line forward you tap the trimmer head lightly against the ground
while the engin e runs at full speed.
- Hold the trimmer at an angle towards the area that is to
be cut
- The illustration shows the best cutting angle ( A ).
- Use the cord to cut. Do not force the trimmer head into
grass that has not yet been cut. Wire and fences are
hard on th e line and may even cause it to break Stones
and walls, and wood cause the cord to be worn down
very fast. Walk around trees and bushes. Bark and trees, wood boarding and poles
are easily damaged by the cord.
8. Replacement of cord
1. Stop the engine.
2. P ress each side of the cord house, the cover can now be removed.
3. Dismount the cord roller by pulling it. Let the spring ( B ) stay on the
spool. Remove any remains of the cord. Take 3 - 4 m cord (2,4 mm)
and place it double.
4. The two ends are stopped in the 2 holes on the cord roller. Thereafter
you roll the cord on in the direction of the arrow. Avoid twisting the
cord. When all the cord has been rolled on you cut it and pull the two
ends through the cord guides. DON T OVERFILL THE SPOOL!
5. Mount the cord house in opposite order, start by replacing the spring
and place thereafter the cord in the two holes of the cord house.
6. Finish by mounting the cover make sure it is mounted safely.