Fuel
- This product is equipped with a two-stroke engine that needs two-stoke oil added to
the gasoline.
- Always use unleaded fuel (octane 95).
- Never use already mixed petrol/oil from gas stations that is normally used for
mopeds, motorcycles i.e.
- Always follow the directions from the supplier of the oil regarding the mix of oil and
petrol.
- Use a clean and approved gasoline can for mixing the oil with the petrol.
- Use an approved two-stroke oil for air cooled engines, chain saws, trimmers.
(Do not use oil for outboard motors or car oil). Mix only in small quantities.
- Texas recommends Texas Motex 2TX mixed 2%. Mix 0,1 l Motex 2TX oil with 5 l
unleaded gasoline. If another oil is used a 4% mixture is required. But you should
always follow the directions given to you by the manufacturer of the oil.
- Mix the oil and the gasoline thoroughly and shake the mix before tanking.
- Never use a mix of gasoline and oil that is more than 90 days old as this may lead
to problems starting the engine. Never store the same mix in the tank for more than
30 days.
- When storing the machine for more than 30 days you should empty the tank.
Filing of gasoline – Smoking prohibited!
1. Unscrew the gasoline lid. Place it on a clean surface.
2. Carefully pour the oil mixed fuel into the tank. Beware of spilling.
3. Screw the lid on tightly. Wipe away any spilled fuel.
4. It is normal that the engine smokes the first time it is used.
Notice ! Always turn off the engine before fuelling. Never add fuel onto a machine that is
running or when the engine is hot. (Cooling time at least 2 minutes). Move more than 3
meters away from the place where you add fuel on the engine before it is started.
To Next Page
Loading...
