Need help?Do you have a question about the Texecom CAPTURE D20 and is the answer not in the manual?
General| Detection Method | Passive Infrared |
|---|---|
| Power Supply | 9-16 VDC |
| Type | PIR Detector |
| Detection Range | 20m |
| Detection Angle | 90° |
| Field of View | 90° |
| Mounting Height | 1.8 to 2.4 meters |
| Output | Alarm relay output |
| Alarm Relay | NC |
| Operating Temperature | -10°C to +55°C |
| Tamper Protection | Front and rear tamper |
| Dimensions | 50mm |
Instructions on how to open the motion detector, including details about the locking mechanism.
Guidance on choosing the correct location for device installation, avoiding obstacles and false alerts.
Illustrates common causes of false alerts and correct placement for motion detectors.
Emphasizes mounting the device on a stable, flat surface to prevent false alarms.
Details on using appropriate screws and fixings for secure device mounting.
Guidance on how to route cables correctly through the device.
Identifies the terminals on the device and their functions for wiring.
Illustrates End-of-Line (EOL) wiring connections for specific control panels.
Details the default G2 mode settings for optimum performance and false activation immunity.
Instructions for configuring Pet mode, including switch settings and pet immunity specifications.
Explains the CloakWise detection algorithm for distinguishing intruders, even when masked.
Guidance on performing walk tests to ensure adequate coverage and check for obstructions.
To Next Page