INS627-8 19/44
are incorrectly fitted the firmware will detect this on power up and flash both
comfort LED’s for approximately 10 minutes. While the unit is in this state it will
not learn to a panel. After approximately 10 minutes the unit will power off in order
to save energy.
1.10 Learning the Sounder (Odyssey X-W only)
As with all Ricochet enabled devices, the sounder should be learned to the control
panel along with all other devices BEFORE it is installed in its final location.
The Odyssey X-W are learned to a Zone on the control panel in the same way
that Ricochet enabled detection devices are. The Zone type and Ricochet Device
Mode is automatically assigned based on the type of device being learned. In the
case of the sounder the Zone Type is set to "Custom" and the Ricochet Device
Mode is set to Device Specific. These should not be changed. Zone attributes 1 & 2
and Chime options will be ignored for Ricochet enabled Sounders.
You can learn the device from first power up following "Confirm Devices" or
from the dedicated Ricochet Learn menu.
The Odyssey X-W has no Learn Switch, learning is initiated by connecting
the batteries via the Power Jumper
To learn the Odyssey X-W to the system follow the diagram below.
If you need to delete and relearn the device, the On/Off jumper MUST be located
in the OFF position on not simply removed. Removing the jumper does not reset
the unit and it will go into and unknown state.
To Next Page
Loading...
Need help?
General
