Texecom PREMIER 168 - Part Arm System

Premier Series User Guide Operating the Alarm System
INS177 15
To PART Arm the System
The system is PART Armed, when ONE OR MORE zones have been left OFF (omitted)
i.e. the landing or a bedroom.
!"
The system is only Part Armed when zones are omitted using the ‘Part Arm’ procedure
(omitting zones manually (see page 21 for details) is not classed as Part Arming).
The bottom line of the display is programmable for each Part Arm.
Your Installer may have programmed the system so that it can be part armed by
just pressing
!
,
0
or
,
followed by
'
if this is the case then there is
no need to enter the User code below.
To part arm the system, proceed as follows:
Ensure that the premises are secure (all windows and doors not
being omitted are closed) and the Ready light is on.
Enter a valid User code
1111
K($6(=$9"13$3(
%&'$+653,'E
Press
'
K($6(=$9"13RV
0-,1.12$"&'
Use keys
!
-
,
to select the required part arm
K($6(=$9"13RV
D,H3.',$"&'
Press
#
to arm normally or press
&
to arm silently
The exit tone will sound (if silent arm has not been selected)
%&,"5$.1$0W.3$L
$$$$%)))))))$
Leave the protected area
When the system has armed, the exit tone (if sounding) will stop
D,H3.',$"&'
$$$$%)))))))
I$$8%4<$%470K$$I
$<=,$>?$7"&$@>>A
The system is now part armed.