Texecom PREMIER 168 - Cancel Exit Mode; Clear an Arm Fail

Operating the Alarm System Premier Series User Guide
18 INS177
To CANCEL the Exit Mode
Once the exit mode has been started you should leave the premise immediately, however,
if for some reason you decide not to leave, the exit mode must be cancelled.
To cancel the exit mode, proceed as follows:
Enter a valid User code
1111
K($6(=$9"13$3(
!"1/,#$0W.3E
Press
#
The exit tone will stop
$$
$<=,$>?$7"&$@>>A
The exit mode has now been cancelled.
To CLEAR an Arm Fail
When the system tries to arm with zones active (open), the internal sounders will sound
and the external strobe will be flashing to indicate a problem. For details on preventing
an Arm Fail condition, please refer to page 10.
!"
If you were not present when the arm fail occurred or you do not clear the arm fail, the
internal sounders will continue to sound and the external strobe will continue to flash.
To clear the arm fail, proceed as follows:
The alarm will be sounding and the display will look something like this:
%&,"$%47$*%\C$L
$$$$%)))))))
Enter a valid User code
1111
The internal and external sounders will stop, the external strobe will continue to flash and
the number of the zone that caused the arm fail will be displayed (in this case Zone 2).
%&,"$%47$*%\C$L
$$$$%)))))))
O(1,$>>@$%/3.-,
D,H&(('$M.1H(9
Enter a valid User code
1111
and press
)
$$
$<=,$>?$7"&$@>>A
The arm fail has now been cleared.