Texecom PREMIER 168 - Silence an Alarm; Reset After an Alarm

Premier Series User Guide Operating the Alarm System
INS177 19
To SILENCE an Alarm
When an alarm occurs on the system, the internal and external sounders will normally
sound for a pre-programmed time (normally 15 minutes).
!"
If you were not present when the alarm activated, the internal and external
sounders may have already stopped but the external strobe will still be flashing.
When alarm information is being displayed, pressing the SCROLL key will slow
down the display and also allow manual scrolling through the events.
To silence an alarm, proceed as follows:
The alarm will be sounding and the display will look something like this:
$$
$<=,$>?$7"&$@>>A
Enter a valid User code
1111
The internal and external sounders will stop and the number of the zone
that caused the alarm will be displayed (in this case Zone 2)
O(1,$>>@$%#"&'
ASRS?)>SF$<=,$>?
<B,$U"##9"6$8.&
The alarm now needs to be reset.
To RESET After an Alarm
USER Reset
Once the alarm has been silenced (see above), the system will need to be reset.
!"
If the system has been programmed to be reset by an Engineer, pressing
)
will not
return the display to normal, if this is the case see ENGINEER Reset (page 20) for details.
The system may have been programmed to be reset by Anti-code, if this is the
case, see ANTI-CODE Reset (page 20) for details.
To reset the alarm, proceed as follows:
Enter a valid User code
1111
K($6(=$9"13$3(
%&'$+653,'E
Press
)
The external strobe will stop, the system will chime
and the display will return to normal.