Texecom PREMIER 48 - Arming the System

Operating the Alarm System Premier Series Master User Guide
14 INS177
To FULL Arm the System
The system is FULL Armed when ALL zones are ON (not omitted).
!"
Your Installer may have programmed the system so that it can be set by just pressing
(
, if this is the case then there is no need to enter the User code below.
To arm the system, proceed as follows:
Ensure that the premises are secure (all doors and windows
closed etc.) and the Ready light is on.
Enter a valid User code
1111
K($6(=$9"13$3(
%&'$+653,'E
Press
0
to Silent arm (if required)
K($6(=$9"13$3(
+.#,13$%&'E
Press
#
to arm
The exit tone will sound (if silent arm has not been selected)
%&,"5$.1$0W.3$L
$$$$%)))))))$
Leave the premises
When the system has armed the exit tone will stop (if sounding)
$$$$
$<=,$>?$7"&$@>>A
The system is now armed.