Premier Elite 12-W/24-W/48-W Quick Start Guide
INS531-4 7
Devices
Introduction
Learn Devices from first power up
Follow the instructions given in INS176-8 or later for the first power up of the
system.
When the "Confirm Devices" menu appears check and make sure all installed
Keypads and Expanders are showing; press
/
and
/
again to confirm.
Providing the system has a Ricochet enabled expander installed, the following
will appear. The flow diagram shows the procedure to learn devices:-
YES to Select:-
Learn Ricochet
/
Learn Device?
Zone ??? N?,E??
Power up Device!
N?, E?, D?? - 20s
Learn Device to
Zone ??? N?,E??
The bottom line of text shows
the one number, the etwork
and the xpander the device will
be learned too.
ZN
E
The bottom line of text shows
the etwork the xpander and
the device slot on the expander.
NE
/
/
/
Us e the / or to
s ele c t dif fere nt z o n es . It is on ly
poss ible to select Zones which
are free.
n nU
N
/
N
Access the Learn Menu using the Omit “Hot” key
From any top level engineering menu pressing the
/
key will
take you to the Ricochet learn menu above.
Menu
/
YES to Select:-
????????????????
YES to Select:-
Learn Ricochet
IMPORTANT
In all cases when entering the Learn menu the next available free Zone will be
chosen to learn a device too. It will not be possible to learn a device to a Zone
that already has a device learned too it. The number of expander’s on the
system will dictate which next “free” zone is chosen to learn too.
When all device slots have been used the following screen will be shown
Pressing the
N/N
key will return you to the Ricochet
learn menu; pressing the
/
key will enter the Delete devices
menu.
Auto Zone Type & Area
When learning devices, if no editing has taken place of the control panel
onboard hardwired zones, these will be switched to Not Used after the first
Ricochet device is learned to the system; the following defaults will be used for
Ricochet devices learned to the system.
Zone Type Area
001-008 Not Used N/A
009 Entry/Exit 1 A
010 Guard Access A
011 & above Guard A
IMPORTANT
If any editing of any of the on board control panel zones is carried out BEFORE
any Ricochet devices are learned too the system, the control panel zones will
remain at factory defaults.
Deleting Devices
Delete Devices
To delete devices from the system, access the Ricochet Learn menu. Any of
the methods previously detailed may be used.
The
/
key is used to access the Delete option.
Follow the flow diagram below to delete devices from the system.
YES to Select:-
Learn Ricochet
/
Learn Device
Zone ??? N?,E?
Delete Device?
Zone ??? N?,E?
Us e the / or to
s el e c t d if fer e nt z o n es . It is o n ly
poss ible to s elect Zones which
have devices learned.
n nU
The
/
key will cyc le
between the Lea rn or Delete
options.
/
N
/
N
/
If all devices are deleted from the system the following will be shown
Pressing the
N/N
key will return you to the Ricochet learn menu;
pressing the
/
key will enter the Learn devices menu.
Summary of Keys used
Key Function
/
Use this key to access the Ricochet Learn menu from
any top level engineering menu.
/
Use this key when in Ricochet Learn menu to delete
devices, or cycle between learn and delete functions
N/N
Use this key to exit the Learn Menu.
To Next Page
Loading...
