Texecom Premier Elite Impaq Contact-W Instruction Manual

INS 468-6
ASSEMBLY
For rear tamper - fix both the detector AND the rear tamper insert to
the mounting surface. Activation of rear tamper will damage product.
Rear Tamper Insert
Relearn
MAG1 COM MAG2
Reed
Disable
Reed Switch
Reed Disable
Magnet
Non-Ferrous Mounting Material
•Maximum Break = 30mm
•Minimum Make = 15mm
Ferrous Mounting Material
•Maximum Break = 15mm
•Minimum Make = 5mm
Note: Values depend on
mounting material. See Fig.1
Disabled
Enabled
Battery
Only replace with 3V Lithium CR123A.
Battery Safety
• Do not throw into a fire
• Do not heat
• Do not charge
• Do not short circuit
• Do not disassemble
• Replace only with same or equivalent type
• Always observe local regulations when
disposing of a battery
• Detector will transmit low battery warning
when battery needs replacing
Relearn
Place jumper on Relearn pin
header and insert battery to
learn device.
For wiring external wired
contacts/switches
LED
INTRODUCTION
• Forwirelessconnectivity,detailedprogramming andsystemset-up
instructionspleaserefertothecompatibleRICOCHET
™
technology
enabledPremier Elitewirelessexpanderinstructions.
• FeaturingRICOCHET
™
wirelesstechnologytheImpaq Contact-Wis
designedforprofessionalsecurityinstallations.
• WhenusingtheImpaq Contact-WonanEntry/Exitroute,ora24HR
door,orwherechimeisrequired,thedeviceattributesshouldbeleft
atdefault“AlwaysAwake”.
• Pleasesee thePremier Elite 8XP-W/32XP-WInstallation Manualfor
detailsofhowtochangethedeviceattributes.
Instruction Manual
Premier Elite Impaq Contact-W

Texecom Premier Elite Impaq Contact-W Specifications

General

Brand	Texecom
Model	Premier Elite Impaq Contact-W
Category	Security System
Language	English