Need help?Do you have a question about the Texecom Premier 832 and is the answer not in the manual?
General| Zones | 8 |
|---|---|
| Expandable Zones | 32 |
| Outputs | 4 Programmable Outputs |
| User Codes | Up to 50 |
| Keypads | Up to 8 |
| Communication | GSM |
| Power Supply | 12V DC |
| Event Log | 1000 events |
| Compatible with | Texecom peripherals |
Overview of the alarm system components and basic operation.
Details the system's capability to monitor fire detection devices.
Explains how the system transmits alarm data to a monitoring station.
Defines protection areas (zones) and their grouping into partitions.
Describes user codes for system operation and security.
Discusses the installation and function of remote keypads.
Lists and describes the different models of remote keypads available.
Illustrates the physical layout of various keypad models.
Explains the purpose of each function key on the keypad.
Details how to use panic and emergency alarm functions.
How to verify system readiness for arming using the Ready light.
Step-by-step guide to arming the system when leaving premises.
Step-by-step guide to arming the system when occupants are present.
Procedure to disarm the system upon entering the premises.
Procedure to disarm the system when not in an entry delay period.
Steps to disarm the system following an alarm event.
How to arm specific partitions in Away mode.
How to arm specific partitions in Stay mode.
Procedure to temporarily disable specific zones.
Procedure to re-enable bypassed zones.
Bypassing multiple predefined zones simultaneously.
Combining zone bypassing with immediate arming.
Function to clear existing alarms and reset latched detectors.
Information on system faults and their indications.
Procedure to acknowledge and clear new faults.
A special procedure for resetting the panel using a unique code.
Controls the audible chime feature for zone violations.
Allows users to change their personal access code.
Accessing and viewing the system's event log on LCD keypads.
Stops any ongoing transmissions to the Alarm Receiving Centre.
Overview of how to add, modify, or delete users in the system.
Configuration settings for user access levels to partitions and functions.
Configuration settings for user access to specific features like reporting and time locks.
Configuration settings for advanced user permissions, including engineer access.
Adding users with pre-defined access levels.
Assigning custom text labels to users for LCD keypads.
Procedure for testing all zones and detectors of the alarm system.
Testing the system's audio devices and outputs.
Initiating a test communication to the Alarm Receiving Centre.
Authorizing remote access for installers or technicians.
Setting the system's internal clock.
Setting the system's internal calendar.
Programming custom text displayed on LCD keypads.
Describes the system's behavior during a fire alarm event.
Procedure for resetting smoke detectors after an event.
Guidance for a home safety check to minimize fire risks.
Instructions for creating and rehearsing a fire escape plan.
Routine care and upkeep recommendations for the system.
Definitions of technical terms used in the manual.
Details for recording control panel model and location.
Table for recording keypad location and partition assignments.
Table for recording various timer settings for partitions.
Table for recording user numbers, names, and associated numbers.
Table for recording zone numbers, locations, and attributes.
To Next Page
