Texecom Premier 832 - System Program Menus

System Program Menus Premier 412/816/832 Master User Manual
14 INS141-6
4. System Program Menus
The Master User and Users with the relevant access level
can access the System Program Menus. These menus allow
the users access to the more advanced features and
functions of the alarm system.
The following programming menus are available:
Menu Function Page
Programming Users
!", Program User 16
!#, User Options 1 17
!$, User Options 2 17
!%, User Options 3 17
!&, User Text 18
!', Program Standard Users 18
System Tests and Utilities
(", Walk Test 20
(#, Test Speakers and Outputs 20
($, Send Test Call 20
(%, Enable Download Access 20
(&, Start Call Back 20
(', Program Time 20
(), Program Date 20
(*, Program Banner Text 20
(!, Print 100 Events 20
((, Exit Program Mode 20
"
Menus !" - !' are restricted to Access
codes enabled for Code Programming (Master
Users).
Menus (" - (! are restricted to Access
codes enabled for User Programming.
To abort programming at any stage and preserve the
original settings, press -.
The alarm system will automatically exit program
mode if no key is pressed for 60 seconds.
To access the programming menu, enter your Access
code
6666 and press - followed by (:
Programming Menu
Enter Code > ??
Armed
Zones
87654321
Ready
Alarm
Service
Enter Access code
Then press then
????
N9
All Zone lights lit and
light flashesReady
Enter menu command
??
A programming menu is selected by entering a two-digit
menu code. On completion of each menu option, the
system reverts to the main programming menu, allowing
other programming menu options to be accessed.
To exit the programming menu, enter (( or press the
- key, the system will revert to normal operation:
Programming Menu
Enter Code > ??
Armed
Zones
87654321
Ready
Alarm
Service
All Zone lights lit and
light flashesReady
To exit programming mode,
enter or press
99 N
Premier 816
12:45.59 28/04
Armed
Zones
87654321
Ready
Alarm
Service
All zones clear and
light on.Ready
LCD shows banner text
and time/date.
Programming Text (LCD Only)
Text is programmed in a similar way to mobile phones.
Characters are selected by pressing the corresponding key
the appropriate number of times (to select a character on
the same key, press 7 to move the cursor along).
The table below shows the keys to use and the characters
that are assigned to them:
Key Characters
!
. , ? ! 1 @ “ - &
#
a b c 2 A B C
$
d e f 3 D E F
%
g h i 4 G H I
&
j k l 5 J K L
'
m n o 6 M N O
(
p q r s 7 P Q R S
)
t u v 8 T U V
*
w x y z 9 W X Y Z
+
_ 0 , # * Custom characters
,
Move cursor left and right
-
Backspace (delete)
.
Accept text