Texecom Veritas Excel User Manual

Using Your Alarm Veritas Excel User Guide
4 INS166
Using Your Alarm
Introduction
The display will normally show the date & time:
%-$.)*/0%%12+$3%
45%67.%%58944:44%
! "
The top line of the display can be programmed by your Installer.
When a valid 4-digit Access code is entered
####
, the display will
read as follows:
;"<$%6++$7*$<%
1#*$.%;"==/#<%
! "
If no keys are pressed, the display will revert back to normal after 16
seconds.
Zone Faults During Setting
If an attempt is made to set the system with any zones ‘open’ (e.g. door ajar,
open window, etc.) the display will show the numbers of the open zones. The
control panel will also sound a repeating series of bleeps corresponding to the
open zone number (i.e. Zone 1 bleeps once, Zone 2 bleeps twice, etc.).
If more than one zone is open, the bleeps will correspond to the highest zone
number (i.e. if Zone 2 and 5 are open, the control panel will bleep 5 times). The
display will look something like this:
>?33%@$*%@?)*$%
!"#$0%:8::A:::::%
! "
To display the descriptive text associated with a particular zone number,
press and hold the corresponding key
#
##
#
.
While one or more zones are open, the exit timer is suspended. Open zones that
will be closed during exit (e.g. entry zones, like the front door) may be ignored,
other open zones should be closed. The exit tone and timer will resume when all
zones are closed. If it is necessary to leave a zone open then it must be omitted
(see page 6 for details).
! "
If an open zone cannot be closed then it may be ‘in fault’, if the fault cannot
be corrected contact your alarm company.

Texecom Veritas Excel Specifications

General

Brand	Texecom
Model	Veritas Excel
Category	Keypad
Language	English