User Guide
4 INS046-8
To UNSET the System
Enter via a designated entry route. The slow entry tone will start. Enter
your 4 digit code
!!!!
. The system will unset and the entry tone
will stop.
During the last 10 seconds of the entry period the entry tone will
change from slow to fast.
To OMIT Zones During Setting
It is possible to exclude (omit) or include individual zones during setting.
Enter your 4 digit code
!!!!
. Press
"
or enter Part Set
Suite number
#
,
$
,
%
or
&
and press
'
. Press
(
. The exit
tone and exit timer will stop and the display will illuminate the zones that
are about to be armed. Press the appropriate numbered button(s)
!
… of the zone(s) to be omitted or included. Press
)
to
complete the omitting procedure. The system will revert to exit mode.
The exit tone and exit timer will restart.
1. The system may be programmed so that some zones cannot be
omitted.
2. The system will automatically revert to exit mode 16 seconds
after the last key is pressed.
3. Whilst omitting, included zones that are ‘in fault’ are indicated by
flashing.
4. Omitted zones that are not ‘in fault’ flash during the exit period.
If a zone is illuminated but the system sounds the exit tone (as
opposed to an error tone) then the open zone is omitted.
To Set the System With a Power Fault
Enter your 4 digit code
!!!!
. Press
"
or enter Part Set
Suite number
#
,
$
,
%
or
&
and press
'
. The system will
sound a repeating series of 10 bleeps. Press
(
. The display will
illuminate the zones that are about to be armed. Press
,
. The Power
light will turn off. Press
)
. The exit tone and exit timer will restart.
To Next Page
Loading...
Need help?
General
