What causes poor load regulation on TEXIO Power Supply with CV LED on?
If you're experiencing poor load regulation on your TEXIO Power Supply and the front panel CV LED is on, it could be due to improperly connected sensing wires. Ensure that the sense wires are connected according to the user’s manual instructions.
How to troubleshoot a TEXIO PU6-100 Power Supply with no output and blank displays?
First, check if the AC power cord is defective by checking its continuity and replacing it if necessary. Also, verify that the AC input voltage is within the acceptable range and connect the power supply to an appropriate voltage source.
What to do if my TEXIO PU6-100 Power Supply output is present momentarily but shuts off quickly and the display indicates “AC”?
Check the input AC voltage. If the AC source voltage sags when a load is applied, connect the power supply to an appropriate voltage source.
Why TEXIO Power Supply output voltage will not adjust and front panel CC LED is on?
The unit may be in constant current mode. Check the current limit setting and the load current.
What to do if my TEXIO Power Supply output is present momentarily but shuts off quickly and the display indicates “OUP”?
The power supply might be configured to Remote sense. Check if the positive or negative load wire is loose.
Why does my TEXIO Power Supply have no output and blank displays?
If your TEXIO Power Supply shows no output and all displays and indicators are blank, there could be a couple of reasons: * The AC power cord might be defective: Check its continuity and replace if necessary. * The AC input voltage might be out of range: Verify the input AC voltage and connect to an appropriate voltage source.
Why won't the output current adjust on my TEXIO Power Supply when the CV LED is on?
If the output current on your TEXIO Power Supply won't adjust and the front panel CV LED is on, it indicates that the unit is in constant voltage mode. Check the current limit and voltage setting.
What to do if TEXIO Power Supply output voltage won't adjust and CV LED is on?
If the output voltage on your TEXIO Power Supply won't adjust and the front panel CV LED is on, check whether the output voltage is adjusted above the OVP setting or below the UVL setting. Set OVP or UVL so they will not limit the output.
Why does my TEXIO Power Supply shut off quickly and display 'AC'?
If your TEXIO Power Supply output is present momentarily but shuts off quickly, and the display indicates “AC”, it could be due to the AC source voltage sagging when a load is applied. Check the input AC voltage and ensure it's connected to an appropriate voltage source.
What to do if my TEXIO PU6-100 front panel controls are nonfunctional?
The power supply might be in Local-Lockout mode. Turn off the AC power and wait until the display turns off. Then, turn on the AC power and press the front panel REM/LOC button.
General| Model | PU6-100 |
|---|---|
| Category | Power Supply |
| Output Power | 600W |
| Line Regulation | ≤0.01% + 2mV |
| Cooling | Forced Air Cooling |
| Output Voltage | 0 to 6V |
| Output Current | 0 to 100A |
| Interface | RS-232C |
| Operating Temperature | 0 to 40°C |
| Dimensions | 215(W) x 130(H) x 350(D) mm |
To Next Page
