Why is my TEXIO PSF-1200L not turning on?
If your TEXIO Power Supply isn't turning on, even when the power switch is on, there are a couple of potential reasons. First, the AC power cable might be damaged or not properly connected; check the connection or replace the cable. Second, the input fuse might have blown, which could indicate that the input voltage is outside the allowable range.
What to do if TEXIO Power Supply output is unstable?
If the output of your TEXIO Power Supply is unstable, it might be oscillating due to the load's influence. Try twisting the load or sensing wires, or change the wire layout. You can also connect a capacitor at the output end of the power source or the load end.
What to do if TEXIO Power Supply displays OHP after starting?
If your TEXIO Power Supply displays 'OHP' after starting, it means the Overheat Protection (OHP) function is active. You should check the ambient temperature, air intake and exhaust ports, and the dust filter.
Why is OCP displayed when I press the OUTPUT key on my TEXIO PSF-1200L Power Supply?
If 'OCP' is displayed when you press the OUTPUT key on your TEXIO Power Supply, it indicates that the Over Current Protection (OCP) value is set too low.
Why is OVP displayed when I press the OUTPUT key on my TEXIO PSF-1200L Power Supply?
If 'OVP' is displayed when you press the OUTPUT key on your TEXIO Power Supply, it could be due to a few reasons: * The OVP (Over Voltage Protection) value might be set too low. * The sensing wire(s) might be disconnected. * The resistor might be open in the external resistance control mode.
What to do if display disappears quickly on TEXIO PSF-1200L?
If the display on your TEXIO Power Supply disappears shortly after starting operation, the fan might be stopping. Check the fan to ensure it is functioning correctly.
How to fix no output on TEXIO Power Supply?
If your TEXIO Power Supply provides no output even when the OUTPUT key is pressed, there are several potential causes: * The set voltage is at '0V'. * The set current is at '0A' (in Constant Current status). * Output On/Off is controlled by external contacts. * The channel output key is not selected, or an incorrect channel is selected. * The keys are locked.
Why TEXIO Power Supply current cannot raise to the set value?
If the current on your TEXIO Power Supply cannot be raised to the set current value, it could be because Constant Power (CP) operation is active, or the CP value is set too low.
Why won't the output voltage fall on my TEXIO Power Supply?
If the output voltage on your TEXIO Power Supply does not fall, it's possible that the Hi-? function is activated.
What does it mean when TEXIO Power Supply displays '----'?
If your TEXIO Power Supply displays '----' after starting, it means the unit is specified as a slave unit. Specify the unit as the master unit.
General| Model | PSF-1200L |
|---|---|
| Category | Power Supply |
| Output Power | 1200 W |
| Input Voltage | 100-240 VAC |
| Input Frequency | 50/60 Hz |
| Ripple Voltage | ≤ 10 mVrms |
| Load Regulation | ≤ 0.01% + 3mV |
| Line Regulation | ≤ 0.01% + 3mV |
| Display | 4.3 inch TFT LCD |
| Cooling | Forced air cooling |
| Output Current | 0 ~ 10A |
| Ripple & Noise | ≤ 10 mVrms |
| Interface | RS-232, USB |
| Operating Temperature | 0 to 40 °C |
| Storage Temperature | -20 to 70 °C |
| Weight | 10 kg |
To Next Page
