8-8-3. Output current setting (：CURR)
This command sets or inquires about the output current.
Sets the output current of a one-output model.
Sets the output current of CHA.
Sets the output current of CHB.
The <value> range in single-unit operation is as shown below:
PSF-400L & PSF-400L2: 0.00 to 41.00
PSF-800L: 0.00 to 82.00
Two decimal places are valid.
The setting range changes in power extension master-slave
(parallel) operation.
Resolution in parallel operation: 100mA
Setting range: 0.0 to (total current x 1.025)
Sets the output current of a one-output model to 10.10A.
Inquires about the set output current of a one-output model.
Inquires about the set output current of CHA
Inquires about the set output current of CHB.
10.10
Indicates that the set output current is 10.10A.
In tracking operation, setting of the CHA reflects upon the CHB
and CHB setting causes an execution error.
To Next Page
