Textron Bell 412 - Page 193

BHT-412-MM-2
5-00-00
15 DEC 2015 Rev. 23 Page 147
Export Classification C, ECCN EAR99
Figure 5-5. Aft High Crosstube — Special Inspection (Sheet 2 of 2)
412_MM_05_0002b
1.
2.
3.
4.
5.
6.
Clamp assembly
Abrasion strip
Aft crosstube
Upper support
Larson L101 abrasion strip
Lower support
3
6
4
5
0.05 TO 0.15 IN.
50 TO 70 IN-LBS
(5.6 TO 7.9 Nm)
T
DETAIL B
VIEW LOOKING FORWARD
1
2
3
Remove paint/primer from the aft crosstube (3) on the left and right-hand sides.
Protect abrasion strip (if installed) during paint removal process.
Protect upper and lower supports (4 and 6) during paint removal process.
NOTES
3
3