Textron Bell 412 - 5-35. 3600 HOURS TOTAL AIRFRAME TIME AND EACH 300 HOURS;12 MONTHS INSPECTION

BHT-412-MM-2
5-00-00
Export Classification C, ECCN EAR99
SPECIAL INSPECTIONS
5-35. 3600 HOURS TOTAL AIRFRAME TIME AND EACH 300 HOURS/12 MONTHS INSPECTION
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
DATE: __________________W.O. _____________________
FACILITY: __________________________________________
HELICOPTER S/N: ___________________________________
REGISTRY NO.: _____________________________________
TOTAL TIME:_______________________________________
SIGNATURE:________________________________________
NOTE
For helicopters S/N 33001 through 33179 with main
beam cap 205-030-186-005 installed, accomplish at
3600 hours total airframe time and each 300 hours or
12 months thereafter, whichever occurs first. If main
beam cap 205-030-186-005 has been replaced, use
replacement cap total time in lieu of helicopter total
time.
This inspection is not required if main beam cap
205-030-186-005 has been replaced with main beam
cap 205-030-186-101.
TB 412-88-66 MAIN BEAM CAP
Inspect main beam cap 205-030-186-005 as follows:
1. Remove components as necessary to gain access to main
beam cap between FS 164 and 168.
2. Clean exposed area of main beam cap.
3. Inspect cap for crack(s) using a bright light and a 3X
magnifying glass.
4. Log inspection in helicopter log book.
5. Replace components that were removed to gain access.
26 FEB 2013 Rev. 16 Page 185/186